This page explains how to use the
Sipura range of devices to access your fring-a-ling account.
The Linksys PAP2 uses the same firmware, so these instructions also apply to that device.
Log on the the Admin page of the Sipura using the following URL format: http://a.b.c.d/admin/,
where a.b.c.d is the Sipura's IP address.
Click on the Advanced link on the top left of the configuration page.
SIP
Click on the SIP tab at the top of the page. Change this
setting in the SIP Timer Values section:
SIP T1:
1.5
Lines
Configure all lines as follows:
NAT settings
NAT Keep Alive Enable = No
Proxy and Registration
Proxy = sip.fringaling.com
Outbound proxy = [blank]
Register = Yes
Use Outbound proxy = No
Make Call Without Reg = No
Answer Call Without Reg = Yes
Subscriber information
User ID = [Any number. Each line should have a unique number.]
Password = [Your fring-a-ling password]
Auth ID = [Your fring-a-ling account number]
Use Auth ID = Yes
Supplementary Service Subscription
Three Way Call Serv = No
Audio Configuration
G729a Enable = No. (If you are only using one port on the device, you can set this
for "Yes" for improved audio quality. But, the Sipura only allows one
concurrent Low Bitrate Call when this codec is enabled.)
DTMF Tx Method = INFO
Hook Flash Tx Method = INFO
Multiple concurrent calls
Standard fring-a-ling accounts allow only one concurrent call. If
you need to make more than one call at the same time, please explain your requirements to
our support team.
Remote configuration
If you are not confident in performing these changes, then we offer a
remote management service for PAP2 gateways. We can download a configuration to your
PAP2 for a once-only charge of $20.00.
Test calls
We offer a simple test facility on our servers that you are welcome to
use. To call it, dial 123. You should hear a test announcement.If you hear this, then your equipment is set up correctly and you should be able to
use fring-a-ling.
